by NerdAlert3D, published

DREMEL WRENCH by NerdAlert3D Apr 5, 2013

Thing Info

1853Views 511Downloads Found in DIY
Report Thing


Update! I found that although the part printed fine, I only used a 15% fill and it flexes too much when using it on my Dremel. Re-ran a file with 100% fill - stay tuned. I also bumped the scale to 101% to fit the closed end better on my Dremel....

Customized version of http://www.thingiverse.com/thing:69655

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=69655


Using the following options:

DualExtrusion = Extruder1
Tool_Length = 8
Nut_Size = 9.6
ToolOptions = 2
message = DREMEL
kerf = 0.3
Font = write/orbitron.dxf

More from DIY

view more

Thing Info

1853Views 511Downloads Found in DIY
Report Thing


Apps Used


thing App

Liked By

View All



DREMEL WRENCH by NerdAlert3D is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

I printed this up, and the open end doesn't provide a good enough grip on the dremel head to release the bit for me. The closed end is a little small, and needs some tweaking to fit on mine, but you gave me a great start! Thanks for designing this.

Just printed one, fits perfect on both ends, used 50% fill density, open end flexs a little, but closed end is very strong, nice job, thanks.