This is a bare holder to mount your Raspberry Pi B+/2 on so it stands level on the table even with mounted heatsink on the bottom.
You can use my Top Hat Rail / Cap Rail mount base plate (http://www.thingiverse.com/thing:684759) to easily mount your Raspberry Pi into your control cabinet.
There are two versions of the holder:
- One with a flat base for simple table stand or for glue to the flat Cap Rail mount base plate
- One with clips to snap on the version of my Cap Rail mount that has notches
Thread the holes with M2.6 thread cutter before mounting the Pi on it.
Hint: The clips snaps really tight on the notches of the Cap Rail mount. I carefully bent the clips a little bit before putting these two together. You have to use quite a lot force to snap them together. But the PLA I used for printing was flexible enough. Once snapped together it is not designed to be put apart again.
Have fun with it :)