Sliding Sceen Door Lock
by noseydan, published
A lock to suit Traditional Sliding Screen doors (5 parts).
This lock is designed to suit a screen door 15.5mm thick.
Unlike locks that I was able to find commercially this lock will allow you lock/unlock the door from both inside and out.
Print one each of the five parts. All parts can be printed without support you will just need to rotate/position them accordingly.
Print Settings of current Test Lock:
Layer Height:- 2.0
You will need to drill 3 holes through the door, 1 8mm centre hole for the shaft and two 6mm holes for the rods that connect the two handle parts.
You may need to do a light sand to the square end of the shaft to fit into the lock part as it meant to be a snug fit. The shaft is slightly shorter then required so that you can tighten the lock up firm as the lock works on friction to work properly.
I have uploaded the stl files but if requested I can upload the files in a different format, what ever Creo 2 permits.
slidingdoorlock_combined.stl provided for viewing combined lock NOT FOR PRINTING
Liked ByView All
Give a Shout Out
Sliding Sceen Door Lock by noseydan is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure noseydan would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).