Cable Holder (Cable Clip)
by bardiaesm, published
you can either purchase double sided tape from any hardware stores or can insert 2 quarters on the bottom to make it heavier if you dont have access to double sided tape.
CableHolder_FIX file is the normal fixed design, just print it out and tape it to the table. (No support is needed)
CableHolder_with_coin_FIX file has a coin hole underneath for inserting coins so it can become heavy. (Support is needed)
I was inspired by: bluelounge.com/products/cabledrop/
This design was made with SolidWorks
Recent Commentsview all
Thank you for your comment!
I knew about the problem but never got a chance to fix it.
Ive uploaded 2 new files (CableHolder_with_coin_FIX, CableHolder_FIX), in those new files I removed the 2 square holes on the sides you were talking about it.
For file CableHolder_FIX, I removed the coin hole however file CableHolder_with_coin_FIX, still got the hole under it (Its used for inserting coins to make it heavier)
This model has some issues with it. It's not extremely obvious why the bottom has an inset circle? (Are you supposed to glue in magnets or something?) And, there seems to be a square inclusion on both sides. You can see it when it prints, and it's inefficient.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.