Thermocouple sensor, single sided carrier board
10
Likes
176
Downloads
576
Views
Published on March 16, 2011
Description
I wanted a proper board to mount the MAX6675 sensor discussed here: reprap.org/wiki/Hacks_to_the_RepRap_Extruder_Controller_v2.2
Datasheet is here: datasheets.maxim-ic.com/en/ds/MAX6675.pdf
I haven't attempted to use it yet, but it etched cleanly and I had no trouble getting the chip to seat on the pads. There are pads to mount a .1uF capacitor as well, but damn those things are tiny and exactly the same dingy-beige as my carpet.
I'm better with CAD than I am with Eagle, so I welcome a proper Eagle version if anyone wants to put in the time.
Meanwhile, I'll be under my desk with a flashlight and a magnet hunting for capacitors.
Damnitallsomuch.
Datasheet is here: datasheets.maxim-ic.com/en/ds/MAX6675.pdf
I haven't attempted to use it yet, but it etched cleanly and I had no trouble getting the chip to seat on the pads. There are pads to mount a .1uF capacitor as well, but damn those things are tiny and exactly the same dingy-beige as my carpet.
I'm better with CAD than I am with Eagle, so I welcome a proper Eagle version if anyone wants to put in the time.
Meanwhile, I'll be under my desk with a flashlight and a magnet hunting for capacitors.
Damnitallsomuch.
Instructions
The DXF is mirrored for use in the toner-transfer method PCB fabrication.
License
Thermocouple sensor, single sided carrier board by moleofproduction is licensed under the Public Domain license.
More from moleofproduction
You must be logged in to post a comment.