Loading

Inside mounting X switch for larger ob1.4

by Addidis, published

Inside mounting X switch for larger ob1.4 by Addidis Apr 8, 2013

Thing Info

1118Views 301Downloads Found in 3D Printer Parts
Report Thing

Summary

My OB1.4 is larger than the one posted to try to utilize as much print bed as possible. I have squeezed out :
X= 190 Y=200 Z=220

The original switch mount did not allow you to mount the switch inside. This made it bind on the angular supports. This new rev of the switch is longer. It allows you to mount the switch as shown which then if you work with it a bit can barely clear the support and allow you to butt your X carriage the farthest out possible on my printer. It also acts as a lever so you can make slight tweeks to placement. It might not look like it but it clears, and the screws can be shortened.

I'd also like to thank Wired1 this printer is badd ass. Your efforts are greatly appreciated.

More from 3D Printer Parts

view more

Thing Info

1118Views 301Downloads Found in 3D Printer Parts
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App
Top