Wall Mounted Beverage Holder

by Timesaint, published

Wall Mounted Beverage Holder by Timesaint Apr 8, 2013
0 Share
Download This Thing! Customize Order This Printed Tools & Utilities

Thing Info

2409Views 377Downloads Found in Kitchen & Dining
Report Thing


Want to always remember where you put your drink? Do you have a mancave? Is your signifigant other a stickler about coasters? Are you tired of people kicking beers over at parties?

Print a handy wall-mounted beverage holder and solve your locational beverage problems! Supports both cans and bottles, yet prints without supports!


To mount, use two drywall screws spaced 2.5" from each other vertically. Use drywall anchors if you can't find a stud. Screw in until the head is about 1/8" from being flush to the wall. Drop holder down onto screws. If too loose on the screws, tighen screws. If it doesn't fit, loosen screws. Repeat until holder is tight against wall. Enjoy well-located beverage.

More from Kitchen & Dining

view more

Thing Info

2409Views 377Downloads Found in Kitchen & Dining
Report Thing

Liked By

View All



Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This App connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file for p...

App Info Launch App

Kiri:Moto is an integrated cloud-based slicer and tool-path generator for 3D Printing, CAM / CNC and Laser cutting. *** 3D printing mode provides model slicing and GCode output using built-in...

App Info Launch App
KiriMoto Thing App

With 3D Slash, you can edit 3d models like a stonecutter. A unique interface: as fun as a building game! The perfect tool for non-designers and children to create in 3D.

App Info Launch App

Add a belt clip maybe?

I tried to print it 3 times with various setup but failed 3 times. When printing the top arc, there is a bit of warping. The extruder hits it and either the thing falls or the motor skips steps.
I was using a prusa i3 and abs.
Very nice design.

I tried printing this, but slicer made it 1 big cup. Going to run it through netfab and remove the errors slicer spits out and try again.

Should print in about 3hrs at .2 layer. I thought there was enough plastic on the roll for the print, turns out not so much, so it got two-toned at the top. Designed to be strong and attractive, yet save on plastic and print without supports.