Loading

Rostock Budaschnozzle Mount w/Cold End Fan Shroud

by Av8rRC, published

Rostock Budaschnozzle Mount w/Cold End Fan Shroud by Av8rRC Apr 9, 2013

Thing Info

5203Views 647Downloads Found in 3D Printer Parts
Report Thing

Summary

A mount to use the Budaschnozzle on the Rostock Max. And a mount to add a fan to keep the transition zone cold, a requirement to successful PLA printing.

For more info checkout http://forum.seemecnc.com/viewtopic.php?f=54&t=1548

Instructions

For mounting the Budaschnozzle you will need 3 @ 2.5" long 6-32 screws, w/ nylon lock nuts. And threaded 6-32 spacers, 1.5" long for each screw. Larger than 0.25" diameter standoffs may cause interferance with the Budaschnozzle.

For the fan mount you will need a 25mm x 25mm fan and #3 wood screws. Do not use a fan thicker than 10mm. Otherwise it will cause interferance with the delta arms. If using a 10mm wide fan, I recommend cutting away the bottom two corners to clear the delta arms at extreme outer moves. A 5mm wide fan should be the best size for Delta arm clearance, and should provide plenty of cooling air for the transition zone.

More from 3D Printer Parts

view more

Thing Info

5203Views 647Downloads Found in 3D Printer Parts
Report Thing

Liked By

View All

Tags

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

I think you should mention that this mount is for older buda's, my 2.0 doesnt fit properly, the heater block would be inside my effector if I installed it with this, I really wish it would work though.... I was hoping for a pushfit one....

Top