wades idler nut nobs
3
Likes
257
Downloads
250
Views
Published on March 21, 2011
Description
this enables wades idler to be adjusted by hand. it should work on m4 and m5 nuts OK. i mistakenly stated it was for m3. my bad. i may follow up with a parametric design.
Instructions
print out 4 nobs from stl file, press 4m or 5m nut into inset, and hold solder gun to nut to push in in and hold it in place. reverse your normal wades setup placing bolt top in back of wades, and place nuts into nob holder and then place idler, and springs, then thread the nuts on by hand. tighten till snug.
License
More from jamesvilleneuve
You must be logged in to post a comment.