by sbork, published
This is a removable mount for the Kinect. It should fit very tightly and you can use a flat screw driver to unlock the clips. You can also break them and print the small clips for future use of the mount. It is loosely inspired by Henkka's and Chooch Kinect supports.
Recent Commentsview all
Liked Byview all
Give a Shout Out
I got a very good result on a Replicator 2 using PLA plastic and medium quality preset.
Note that the clip (kb-hook) must be printed lying on a side.
Once you printed 2 clips and the base, push the clips from the bottom up through the base with the clip's hook facing outside.