gopro monopod mount for diving

by big_red_frog, published

gopro monopod mount for diving by big_red_frog Apr 13, 2013

Thing Info

6655Views 556Downloads Found in Camera
Report Thing


SImple monopod mount for gopro camera.
Has captive tie wrap holes.
Used successfully in Bahamas for Shark dive, worked great.
Print solid to avoid any air cavity.
Printed in PLA on replicator 2, where I get no shrinkage, so fit is very good, and captive nut is tight.


Print Solid.
Orientate so that concave face is down, auto-generated STL images in thumbnails are misleading, do not print on side as in image.
Print with supports, and clean out cable tie holes with small file.
Clean out threaded shaft hole with the threaded shaft of a gopro mount bolt.
Clean out captive nut recess with a small sharp file.
5mm or thinner cable ties.
Mount round thinnest shaft on monopod. Insert a flat sticky foam to impove grip between mount and shaft if necassary.
Use 2 extra standard Gopro shaft sections between camera and mount to allow camera to face forward or in line with monopod.


More from Camera

view more

Thing Info

6655Views 556Downloads Found in Camera
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

I'd be holding my breath too!

wow :D :D very stylish picture!