EiNSTeiN Variant Compact Extruder for i3 / 2engineers Motor
by goopyplastic, published
Recent Commentsview all
it is intended for 3mm yes. I used a standard mk7 drive gear. I am not really sure on the other measurements but it is intended as a jhead mount. this should be the correct scad file:
(1) Is this designed to work with 3mm filament?
(2) What is the outer diameter of the filament drive gear you're using?
(3) What is the height of the groove (bottom, narrower) part on the mount?
I'm using a "Raptor" gear which has an effective 10.5mm diameter, so I want to make sure to align the filament holes properly.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.