Loading

Skull

by tmorris9, published

Skull by tmorris9 Apr 15, 2013

Thing Info

10479Views 2948Downloads Found in Sculptures
Report Thing

Summary

I did not create this, I got it from GrabCad but I sliced the bottom off so it prints better and when printed it sits on the table better, won't wobble or tilt. I also scaled it down.

Here is the original http://grabcad.com/library/skull--6

Instructions

You will more than likely need support. I used Slic3r 0.9.9 and it's support was really easy to clean off. Better than any other version so far.

More from Sculptures

view more

Thing Info

10479Views 2948Downloads Found in Sculptures
Report Thing

Liked By

View All

License

Skull by tmorris9 is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

Excellent print. Thanks

I have this same skull but sliced to print without support. Check it out http://www.thingiverse.com/thing:43591http://www.thingiverse.com/thi...

Sliced Human Skull with Mandible and Teeth
Top