Loading

Big Doorstop

by SLAM-ER, published

Big Doorstop by SLAM-ER Apr 16, 2013

Description

This is doorstop that I designed in Sketchup as my first fully homemade 3D print... thought I'd upload it since I had it sitting around. It's 40 x 40 x 120mm so not huge, but probably bigger than it needs to be unless you had a really big gap under your door! The bottom surface is designed to grab onto carpet without damaging the pile and the top is stepped to grip the bottom of the door nicely.

Recent Comments

view all

Fair enough - nice work!

Not too hard really, I just drew a square, cut into 2x triangles, then dragged
the corner nodes up, then copied it and pasted it, rotated and snapped
to the corners, till I had the 4x pieces to make one 'bump', then copied
and pasted that to make the rest of the base.

Not really, I just drew a square, cut into 2x triangles, then dragged the corner nodes up, then copied it and pasted it, rotated and snapped to the corners, till I had the 4x pieces to make one 'bump', then copied and pasted that to make the rest of the base.

More from Household Supplies

view more

Liked By

view all

Tags

License

Big Doorstop by SLAM-ER is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Download it and print it. A higher fill density might be required so you dont crush it with the door.

Comments

You must be logged in to post a comment.

SLAM-ER on May 28, 2013 said:

Not really, I just drew a square, cut into 2x triangles, then dragged the corner nodes up, then copied it and pasted it, rotated and snapped to the corners, till I had the 4x pieces to make one 'bump', then copied and pasted that to make the rest of the base.

markbrannan on May 28, 2013 said:

How did you make the bottom surface in SketchUp? It'd be pretty painful to do by hand.

SLAM-ER on May 28, 2013 said:

Not too hard really, I just drew a square, cut into 2x triangles, then dragged
the corner nodes up, then copied it and pasted it, rotated and snapped
to the corners, till I had the 4x pieces to make one 'bump', then copied
and pasted that to make the rest of the base.

Top