30mm box section end cap or foot
by Wired1, published
Push-in foot or end cap for 30mm box section steel.
Handy if you are fabricating something like a table, or in my case a gravity racer, and want to clean up the open ends of a few chassis parts.
Just print it and when it cools down, press it into the box section.
I printed these at 40% fill with 2 perimeters and tops & bottoms.
Liked ByView All
Give a Shout Out
30mm box section end cap or foot by Wired1 is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Wired1 a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Wired1 would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).