by Seadevil, published
5th attempt at a cable mount. (drawn in sketchup, cleaned with netfabb) I had problems with the clip being too brittle and tried to fix it by fattening the clip. Didn't work? Maybe I need to change some slic3r setting?
This is supposed to hold the '3/8" Flex Tubing' cable sleeve I got from Home Depot (part# FLX-3810T). The bottom foot should mount on the ord-bot hadron x carrage using the 2 holes on the upper right side of the carriage plate.
I finally got #5 to print as a usable part. Previous prints were too brittle. I used 1.75mm white ABS (measured 1.60-1.63) and set slic3r to use 120% extrusion. (Previous parts had linear voids at fracture points.)
Tested this against the Tubing Sleeve and it is a tight fit. Once I mount it on the printer I'll post a picture showing the fit.
Liked ByView All
Give a Shout Out
cablemount1 by Seadevil is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Seadevil a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Seadevil would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).