Clip-on Hook - parametric
by MichaelAtOz, published
I designed this to hang the sink plug off the tap to keep it out of the way, but it may be usefull for other purposes.
Liked Byview all
Give a Shout Out
Make your own with OpenSCAD, or if your tap is close to the STLs, try one.
The STLs are named with the diameter, the thickness and the height, using "-" instead of a decimal point (ie 19-5 = 19.5mm).
Note that slic3r did an interesting thing with the 2.5mm thick ones, it did not produce top/bottom full layers, resulting in a much more springy Thing, see the photo with the fingers. The 3mm one had a top/bottom and was more solid.
I found the diameter needs to be slightly larger than that measured.
Change the X scale on line 10 for oval taps (1.2 worked for me)