Bottle
18
Likes
393
Downloads
2911
Views
Published on April 10, 2011
This thing was Featured on April 14, 2011
Description
This is a (horrible... haHahAhahhaahhhaahHHaaAA) simple bottle I made in a (horrible... hahahaaaarrrrgghhhh) openscad.
Just intended to show that thingiverse.com/thing:7703 by aubenc :-) can be worth for some designs.
The worse in this bottle is that... IT'S EMPTY !! we'll need to find a way to fix that.
The best is that... it's perfectly usable. The walls are 1mm thick.
The biggest outer diameter is 65mm (or may be 64mm... I don't remember).
I was not paying much attention to center the build platform so it was crashing against the z-extender. You can see that in one of the pictures.
More pictures: aubenc.imgur.com/beer_bottle#ztXs3
I almost forget to mention... this thing is 220mm tall
Just intended to show that thingiverse.com/thing:7703 by aubenc :-) can be worth for some designs.
The worse in this bottle is that... IT'S EMPTY !! we'll need to find a way to fix that.
The best is that... it's perfectly usable. The walls are 1mm thick.
The biggest outer diameter is 65mm (or may be 64mm... I don't remember).
I was not paying much attention to center the build platform so it was crashing against the z-extender. You can see that in one of the pictures.
More pictures: aubenc.imgur.com/beer_bottle#ztXs3
I almost forget to mention... this thing is 220mm tall
Instructions
Print/fill/drink/go to the hospital because ABS is not healthy to store drinks.
You must be logged in to post a comment.
aubenc
on
June 19, 2011
said:
love it !
Now this...
aubenc
on
June 19, 2011
said:
or, even better, remove the lower components of http://www.thingiverse.com/thi..., install longer rods plus http://www.thingiverse.com/thi... and then print a scaled up bottle with a size of 100x100x300, that would make one of the biggest things cupcake'd (if not the biggest)
License
More from aubenc
Oh it's not horrrible...I love it! Hope you don't mind but I featured it in a blog :)
http://www.faberdashery.co.uk/...
Hope you don't mind that I don't mind to see it in your blog :-P Thanks!!
It will still take a while before I'm ready to use PLA, anyway, I've added your shop to my favorites. In the meantime: lots of success with your business !!!