Power supply holder(tricky to configure)
by Jasper1984, published
Holds a power supply (or a similar shaped box) to a wall. Obviously you dont
want it to fall! Make sure it is secure!(your safety is your responsibility)
You'll have to fit it to your situation. Which is why i havent provided the
.stl. To be honest, this is quite involved.
pt are the plank length and width respectively.
If it is a general box,
psl, is the length.
pshb are the height
front and back, not 100% if that works you could just set them the same.
wd is the distance you have between the plank and the wall.
dz are respectively the distance of the box from the wall and plank.
You can use tape when it is too big. And a file to make it bigger if too small.
In some cases double-sided tape may help too.
I got the location of the screws wrong!
sbd are supposed to be
respectively the distance of the screw holes from the back and front.
Liked ByView All
Give a Shout Out
Power supply holder(tricky to configure) by Jasper1984 is licensed under the GNU - GPL license.
What does this mean?
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Jasper1984 a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Jasper1984 would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).