LEDclip Ultimaker Inner Front (IKEA Dioder RGB)
by TheSeend, published
LED clips to mount an IKEA Dioder LED strip in the inner left/right front corner of the Ultimaker 3D printer Frame.
Also a "G" shaped template to mark the position of the drilling holes.
Liked Byview all
Give a Shout Out
The default settings of Cura 13.03.
Exceptions Basic Quality:
- Layer Height (mm) = 0.1
- Wall thickness (mm) = 0,8
- Enable retraction = thrue
Exceptions Basic Fill:
- Fill Density (%) = 50
Exceptions Expert config Infill:
- Infill pattern = Grid Hexagonal
- Infill overlap (%) = 50