Ring Holder by sanitrad

Ring Holder by sanitrad Apr 23, 2013

10 9 0

Like 10 Collect 9 Comment 0 I Made One 0 Remix It 0

922 208 Found in 3D Printing

Report Thing as Inappropriate

Description

I made this to hold my rings.

More from 3D Printing

Found in 3D Printing

Report Thing as Inappropriate

Liked By

view all

License

Ring Holder by sanitrad is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

1) I made this project in inventor
2) I created a new sketch, and made circle. The, I extruded it to about 0.25 inches
3) Then, I made another smaller circle on top of the previous one and extruded it to 3 inches
4) After, I made circles on the pole, extruded them inwards, and deleted them to make the holes on the pole the same size as the poles i was sticking in them.
5) I used the revolution tool to make a sphere on top.
6) Isaved my project as an STL.
7) I was ready to print on the makerbot, so I had to generate a G code
8) Finally, I printed to pole
9) When it was done i just cut wooden poles to 1.5 inches and stuck them in the holes.