Mini Cathedral - With Openings!
Description
I thought I'd give it a shot at removing the windows and allowing openings through the form.
So far i've only had time to remove some of the external windows and most of the internal space. And so far it prints rather nicely.
If you have ooze dialed in then this will print quite well.
With time i'll open up all of the openings and see how it goes with printing. As it is i'd anticipate pretty well but time will tell I suppose.
So far i've only had time to remove some of the external windows and most of the internal space. And so far it prints rather nicely.
If you have ooze dialed in then this will print quite well.
With time i'll open up all of the openings and see how it goes with printing. As it is i'd anticipate pretty well but time will tell I suppose.
Instructions
If you can angle your fill layers to 45 degrees then there will be less overhang troubles in the top of the main void spaces of the building. I'm sure i've seen this option but can't recall where off the top of my head.
Regardless it prints well enough and is tricky to fault given its size.
Regardless it prints well enough and is tricky to fault given its size.
You must be logged in to post a comment.
License
Mini Cathedral - With Openings! by Disrespective is licensed under the Attribution - Share Alike - Creative Commons license.
More from Disrespective
Impressive
Most Impressive.