Bracer
6
Likes
349
Downloads
479
Views
Published on April 21, 2011
Description
A simple forearm-protector for archery.
Intended for sporting use. None of that nasty agincourt stuff.
Intended for sporting use. None of that nasty agincourt stuff.
Instructions
The print will fit within an area of 95x95mm, if your print area isn't much bigger than that, you should double-check that it's set out diagonally, which I have tried to make it by default.
File down any edges as desired, I rounded off the corners in the model so they shouldn't be a problem.
Thread some string or elastic cord through the holes and cross it over the outside of your arm so that you have a cross between two lines (some creative thinker might come up with a better way to thread it, but whatever), and adjust it to a comfy fit.
File down any edges as desired, I rounded off the corners in the model so they shouldn't be a problem.
Thread some string or elastic cord through the holes and cross it over the outside of your arm so that you have a cross between two lines (some creative thinker might come up with a better way to thread it, but whatever), and adjust it to a comfy fit.
You must be logged in to post a comment.
License
More from 4ndy
More from Sport & Outdoors
Is it common to get shot in the forearm? I would have thought a chest or head protector more useful :-P
Not for that. Used to prevent the bow string from snapping against the arm when you release the arrow.