Mini Lathe Accessories Holder
by DanLuc, published
I purchased a King Canada miniature metal lathe which came with a ton of accessories, including spare gears which I will eventually print instead of purchase.
The most common used tools including a cutting bit needed to be stored close by. So I made these 3 holders that when put side by side will store all the accessories neatly and within reach.
Update: Made another holder for a chuck and the point that came with the lathe.
I used doublesided tape, but something that has strong adhesion. The chuck grippers are a little heavier. So I made that part twice as thich so I can put more tape on it. Its about 50mm thick where the other two are 25mm thick.
I stuck them closer to the chuck on the back so as not to vibrate as much since the sheet metal is held together closer to the chuck and doesn't move as much in that location.
There isn't any need for support. Just make sure you print the LatheTools part with the wide square opening up since it tapers towards the bottom. thats about it really.
Liked ByView All
Give a Shout Out
Mini Lathe Accessories Holder by DanLuc is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving DanLuc a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure DanLuc would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).