ToM filament guide
16
Likes
568
Downloads
418
Views
Published on April 24, 2011
Description
Just created this filament guide which mounts on top of the ToM, using the screws that hold the back z-rods. (The screws are long enough.)
This is especially useful when you have a filament spool located behind the bot.
This is especially useful when you have a filament spool located behind the bot.
Instructions
The picture shows a less than perfect print on the left and a much better one on the right. The left one was printed as shown. The right one was printed with the long side flat on the build surface. It's best to print this laying down unless you have a bot that's better calibrated than mine. The tall strip isn't very rigid (especially in abs) and you get mush instead of a nice print.
You must be logged in to post a comment.
More from pauldebra
This also looks like the perfect backdrop for a piece of bot bling...