Chademo inlet for test purposes
by erroneus, published
This is still untested, there is only 1 chademo station near me and I don't go that direction very often. (and it may not be working, not sure). I have the printed connector in my car and will test it next time I am there. This is a mechanical test. obviously, there is no pins to make electrical connections.
05/07/2013 - after doing a mechanical test, i found they keyways were too small, so this should be fixed in this version. I probably won't re-print, rather just drill away excess material somehow.
Liked Byview all
Give a Shout Out
It took 6.5 hours with .3mm layer thickness. I printed with support, turned out pretty good.
This is based on the attached PDF file.