3-in-1 spool holder
by mgx, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
A holder for the most common filament spools: 48mm, 38mm and 32mm. It allows the spools to spin freely on a 8mm shaft.
It can be used as printed but it can also take 608 bearings at one or both ends..
Print at 0.4-0.5 layer height (not terribly important), with support. With some luck it is possible to print without support, but cleaning is much harder.
Clean the internal hole with a 8mm drill, if necessary (there should be a 0.2mm clearance around the shaft).
- Push a 608 bearing inside with the help of a vise (and some pieces of plastic to prevent bearing and holder marks).
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
3-in-1 spool holder by mgx is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving mgx a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure mgx would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).