Pi R No Longer Squared!
by rmd6502, published
A round raspberry pi case, inspired by a milled aluminum case featured at http://www.buildingthespin.com.
Edit - Fixed the rotation, but the origin is still off.
Recent Commentsview all
Liked Byview all
Give a Shout Out
3D print in your favorite color. On my Ultimaker I use a scale of 1.02 to allow for shrinkage.
Use an M3 or M4 tap to tap out the screw holes. Place your Pi on the outline on the bottom. If it's a rev 2, use 6mm screws to hold it in place. Put the top on, use 6-10mm screws to fasten it.
Bask in the glory.