Leapfrog Creatr energy chain
by zabana, published
As far as my printer had the extruder cables hitting my prints I was in the need of make them to be organized in a better way.
Also here is a fan spacer to prevent the fanÂ´s stock turbine sound.
Recent Commentsview all
Liked Byview all
Give a Shout Out
Print all pieces, 0.25 height will be fine. (I only needed 20 chain links).
The first link of the chain in the carriage must be clipped reversed to allow a "back" torsion so the chain will not pop out when reaching the X maximun extension to the right.
Also every link must be cutted a little on top to pass through the wires easily.
If the chain hits the right side when homing Y at XÂ´s max print the right side anticrash to prevent it.
In order to apply this upgrade you will need to increase the wires lenght so you will lost maybe your warranty.
Here is a video showing the chain working: