GoPro Hero 3 - Vibration elimination mount
by McNugget, published
You can squeeze your GoPro Hero 3 into the slim case. It is a WIP, because I didn't make any holes for the wireless button (wich you need, so please(!!!) drill a hole there, otherwise your wireless will turn on and off all the time over and over again. And you also should drill a hole for the USB/video-out in case you need the camera for FPV also.
- Print one slim case
- two side holders
- one back plate (made for a rcexplorer.sw TriCopter)
You need four 3mm or similar screws, four small rubber bands and six hear protection plugs. Perfect results when you are able to balance your props and motors. It may even work without perfectly balanced props and motors - please write your experience in the comments down below!
Liked ByView All
Give a Shout Out
GoPro Hero 3 - Vibration elimination mount by McNugget is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving McNugget a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure McNugget would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).