They Like It
Build Platform MakerBot by CidVilas is licensed under the Creative Commons - GNU GPL license.
© 2009 by CidVilas
Instructions
(The two CorelDraw files are the same. Except one is saved in an older version for added compatibility.)
To assemble this there are a few simple steps:
1. Laser cut the two parts
1a. Note the thickness is hairline for cuts and other for raster etch
1b. Insert Magnets *BEFORE* continuing. It will be difficult to push them out after you glue the two pieces together
2.Lay the Raster grid on top of the original builders pad with the words "Build Pad" pointing up and grid pointing up as well
3. Now that they are in place peal back the top pad and place some acrylic cement, or any "super glue" type
4. Clamp it down! Make sure to place plenty of pressure onto the two pads. The flatter the two make a bond the better the surface will be
NOTE: Due to the amount of heat the 'rastered' grid is exposed to, the top pad warps. The bottom pad helps rectify this situation because its of a much thicker material.
