TRAVEL TIC-TAC-TOE
5
Likes
211
Downloads
305
Views
Published on May 8, 2011
Description
This part was made with Tinkercad. Edit the part online at: tinkercad.com/p/acc0f40a14d406e4
Instructions
Print four of these, and line up two of the board prints parallel to each other then flip the other ones upside-down and turn them 90 degrees. all of the notches should fit together to create the tic-tac-toe board.
License
TRAVEL TIC-TAC-TOE by robokid is licensed under the Attribution - Share Alike - Creative Commons license.
More from robokid
You must be logged in to post a comment.