RayBan Aviator simple sunglass case
by HunterGreen, published
This is a simple case for Ray-Ban Aviator sunglasses. The intent is for it to be very slim so it takes up hardly any more space than the glasses, yet sturdy enough to offer real protection. All the cases I see in the stores are either soft (so they protect against scratches but not smacks or crushes), or bulky (five times the size of the glasses). This is a first try; it doesn't have a lid (but the glasses fit so snugly it might not need them, yet slide free easily) or a clip (I plan to make variations with a shirt clip and a sun-visor clip).
Recent Commentsview all
Liked Byview all
Give a Shout Out
I printed mine with a 3mm brim to help make sure it stuck. Probably didn't need it since the bottom is solid, but it does print a while (four hours on my Solidoodle 3) so I just wanted to be sure.
If you don't have your filament width set properly, this can end up being very brittle and breaking along the horizontal plane of the layers.