Alternative Guide Tube Bracket
by malenky, published
Advantage; makes the tubes slightly longer, a little easier to change filament... thats about it.
FYI, this design only clips in the front, so it will tilt when the print heads are farther away, see the last photos I posted.
Recent Commentsview all
Is there a reason you made it so wide? the further it is from the center the more pull when the extruder head is in the corner opposite the spool.
It will do both, and then some! PLA, ABS, and Water Soluble PVA. I eventually would like to experiment with Carbomorph (electrically conductive polymer). With the 2X you can control the speed, quality, and temperature of each extruder, so with some trial and error I suppose you could print anything with a low enough melting point...!?
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.