The ultimate PEG board accessory creator v1.1
by symonty, published
I created this to allow you to make customized TIGHT fitting peg board accessories.
Create U, L, Supported U , and shelves all customizable, 8 variants in all.!
Using the defaults you will get a very nice fit on a standard 1inch / 1/4 hole.
Use supported pieces to allow larger sizes.
## Work in progress.
- Fix accuracy of peg arm length calculations
- Fix round hook issue when thinning width.
- fix larger pegboard holes.
## updates v1.1
V1.1 [ may 5th ] added width and control over the end arm ( for U shapes )
## NOTE: "Customizer app" Issues:-
Issues with the "customizer app" may make you preview not work, the STL is still correct, or try rotate the object in customizer and it will fix itself.
Recent Commentsview all
if you open the object in customizer it will output in stl for you, you can also set all your own options at that time. Enjoy
Ken, the hole size is only reduced by thininng out the hook, this is kinda a bug. I should also reduce the diameter of the nib.
If you are looking to reduce the ofset of the plugs then use peg offset on the second options page.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.