by fantasygraph, published
Recent Commentsview all
have fun.. http://www.thingiverse.com/thi...
oh, so i lied a bit, it's supposed to be, but I made a boo boo (immersed in symmetry forgot to offset the table) and this unit is only 12cm in X for the nearest future. Nonetheless it will be cool even on a 30x30 printer to print bust. You did very fine job on the face of both girls.
Liked Byview all
Give a Shout Out
As usual, my model was tested..and tested.. and can be printed without any support or raft... this is a HUGE model : 138mm tall for a base diameter of 137mm.
it takes a lot of time to print so be sure that your printer is in good shape.
the example are 0.2mm layer, with 10% infill, tested on slic3r 0.9.9 and kissclicer 1.1 RC4
You must be logged in to post a comment.