Improved Bed Mount for RepRapPro Mendel
by ajayre, published
This is an improved bed mount for the version of the RepRapPro Mendel which uses M3 screws to attach the bed. It eliminates the fiddly three nut system and replaces them with a spacer and a single nyloc nut. This makes bed leveling and adjustment much easier.
This is a drop-in replacement for the current M3-based bed mounts.
Insert a M3 nyloc nut into the nut trap on the mount. A small amount of filing may be required but it needs to be a tight fit.
Attach the new mount then attach the bed as follows (top to bottom):
- M3 caphead screw
- M3 washer
- Printed spacer
- Bed mount
The printed spacer is optional depending on your springs. It is the same height as the two M3 nuts that were previously used so when used will put the springs under the same compression as before.
Liked ByView All
Give a Shout Out
Improved Bed Mount for RepRapPro Mendel by ajayre is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving ajayre a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure ajayre would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).