Space Invader Magnet
29
Likes
352
Downloads
770
Views
Published on May 14, 2011
Derived from
8bit Space Invader Ornaments
by 4volt
Description
I used 4volt's dxf to create a space invaders fridge magnet.
Instructions
Print with support. You can print it upside down and you won't need any, but the finish on the bottom is never as nice as the top for me.
This design uses an 18mm diameter circular magnet. The magnet fit and stayed in place very well when printed on my ToM.
This design uses an 18mm diameter circular magnet. The magnet fit and stayed in place very well when printed on my ToM.
License
Space Invader Magnet by mirk is licensed under the Attribution - Share Alike - Creative Commons license.
More from mirk
I modified mine a bit and am using it as cable management on my printer.