Loading

M2 full fan bracket

by Hello18, published

M2 full fan bracket by Hello18 May 8, 2013

Description

M2 fan bracket that attaches the 50mm and 40mm fans to the extruder.

Based off the single bracket by tomlombardi

Ran through netfabb and ready to print, will be updating with an led spot.

Recent Comments

view all

added the v2 of this part as M2fanbracketv2 enjoy

I found that the small round plastic offset and M3x50mm works nicely, with the next redo I'll space the depth of the bracket to fit appropriately so the spacer won't be needed.

The full bracket will keep the offset but will help keep the fans from becoming un-parrallel which I noticed with the single bracket. I also made the depths slightly bigger to help support the weight and vibration which seemed to allow for stress cracks in the single bracket.

More from 3D Printer Parts

view more

Liked By

view all

License

M2 full fan bracket by Hello18 is licensed under the Creative Commons - Attribution license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Comments

You must be logged in to post a comment.

Hello18 on May 13, 2013 said:

added the v2 of this part as M2fanbracketv2 enjoy

Hello18 on May 8, 2013 said:

I found that the small round plastic offset and M3x50mm works nicely, with the next redo I'll space the depth of the bracket to fit appropriately so the spacer won't be needed.

The full bracket will keep the offset but will help keep the fans from becoming un-parrallel which I noticed with the single bracket. I also made the depths slightly bigger to help support the weight and vibration which seemed to allow for stress cracks in the single bracket.

Top