They Like It
Owl Headphone Wrap (SkullyCandy Ink'd Version) by eweinhoffer is licensed under the Attribution - Creative Commons license.
© 2009 by eweinhoffer
Instructions
Some quick words of advice:
-Make SURE the starting position of your extruder nozzle is as close to the midpoint of the build platform as possible. I accomplished this by finding the midpoint with a ruler and drawing a small dot there with a sharpie. This is a very large build, and WILL start to extrude outside the build platform if your extruder is not centered properly.
-Take extra care in making your raft as close to the build platform as possible, to prevent the corners of the build from tapering. If the corners do happen to curve upwards, a small piece of tape should keep it down, and allow the print to continue (Hint courtesy of Will Langford).
-Recommended Skeinforge Settings: Fill: Solid Surface Thickness = 2 layers, Infill Solidity (Ratio) = .4
