by oraltosun, published
Recent Commentsview all
I printed it with my Up! Mini without problem.I gave it to my cousin as a gift. I printed it in small dimensions. (approx. 6 cm tall).
I suggest print it big. Because there are a lot of detail in the wings.
You might be try that to cut the model in half and print it in two parts.
I think the height of the model should be at least 20 cm.
I hope it helps.
I am intrigued by this eagle, But I can't get it to print either, I am not as computer literate as others. It is only printing one side of the Eagle, this is try number 4, Left side appears all there but the right side is not there at all, Bill
Thank you for your comment. Yes , it is a hard model. But i could print it without problem with my Up Mini. It is better to print it big. For example on a larger plate than 12 x 12 x 12 cm .
It is also true that there might be some faults in the model. I just downloaded it from 3D warehouse and export it as STL , repaired it on Netfabb and printed. Everything went well in my printing process.
Sorry for inconvenience.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.