SeeMeCNC Hotend Fix
by MSURunner, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
Here's my attempt at fixing the SeeMeCNC hotend for printing in PLA. RostockHotEndFix4 and the corresponding STL are setup for 40 mm fans, while RostockHotEndFix4.2 and its corresponding STL are for 50 mm fans, each with a 25 mm active cooling fan.
This thing reverses the center platform essentially. Disassemble the hotend bracket and remove the standoffs. Standoffs are placed in the three barrels. Don't be afraid to gentle hammer them in, the bracket is designed to take some abuse. The hotend now gets reassembled with the fans below the center section. The top of the hotend should go (top to bottom) attachment nut, hotend bracket, hotend standoff piece, hotend. Mount and wire fans accordingly.
IMPORTANT: DO NOT FORGET TO ADJUST YOUR FIRMWARE. My build height went to about 328 mm. (Still ridiculously tall and I can now print...)
SeeMeCNC Hotend Fix by MSURunner is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving MSURunner a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure MSURunner would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).