7 wings vase

by toby3d, published

7 wings vase by toby3d May 11, 2013

Thing Info

1512Views 264Downloads Found in Decor
Report Thing


A little vase i made for fun. Broad bottom with some extended volume should give it a strong footing. Hope you like the design! =)

Model was planed to be about 22cm tall and 8.7cm deep/wide.

Have Fun!

NOTE: This little edges inside the twists shouldnd be seen in the end because their angle is very low. They appeared because the shading of the faces where set to flat when i rendered the object.


Used Blender again. Did the modeling with the help of the great modifiers.

More from Decor

view more

Thing Info

1512Views 264Downloads Found in Decor
Report Thing

Remixed From

Liked By

View All


Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This App connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file for p...

App Info Launch App

Kiri:Moto is an integrated cloud-based slicer and tool-path generator for 3D Printing, CAM / CNC and Laser cutting. *** 3D printing mode provides model slicing and GCode output using built-in...

App Info Launch App
KiriMoto Thing App

I know there's a scaling problem with this model. You have to scale it by 1000 to increase it to a height of 22 cm (or less for lower heights)