Rod adapter for Xnaron Printable Magnetic u-joint for Rostocks
by jamesarm97, published
This is an adapter I made so I can use some carbon fiber rods I already had and that are readily available from Hobbytownusa locally. The original files were for 3/8" rods. Mine are about 5.5mm / .188" OD from hobbytown.com/Shop/Carbon-Fiber-Tube-24-188-OD/
Recent Commentsview all
When you changed the arms and joints, did you needed to modify firmware Effector Horizontal Offset and Carriage Offset due to the new positicion (ball centers) or you simply adjusted the Delta Diagonal Rod length?
This one should work. I'm pretty sure I redid one from opens cad source and also tweaked the carriages. I will have to look and see if I can find the files and post them. http://www.thingiverse.com/thi...
Liked Byview all
Give a Shout Out
Main files and instructions:
You must be logged in to post a comment.