Pebble Time charging dock
by gmenke, published
A simple charging stand for the Pebble Time.
I figured the cable clip makes more sense on the other side.
Prints fine without support, just rotate 90° around Y axis.
Added a groove on the bottom for inserting NinjaFlex instead of the rubber feet. I'm not sure how well it prints, though. If in doubt, use Version 4.
Rotate 90° around Y axis for printing.
Print with 100% infill to make it a bit heavier.
Liked ByView All
Give a Shout Out
Pebble Time charging dock by gmenke is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure gmenke would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).