Peristaltic Pump
Description
I have not made and tested this yet, I need someone with a machine to make it. Any volenteers?
Update: I have updated the turret_pump to make it makerbot friendly
Instructions
You must be logged in to post a comment.
So, I can see that the rotor may be an issue since there is no support material. I can take the knob off the bottom, and maybe thicken the entire thing.
I'll update it soon. But I still need someone to print it?!? Please! :'(
I suspect the rotor with the 3 stub axles on could do with being stronger. Not sure how you anchor the rotor to the stepper's axle?
Vik :v)
There is a hole for a setscrew on the turret.
If someone can make one for me, I would be glad to pay some $$. I have the motor and driver already. The thing I am most worried about is if the motor has enough torque. I thought also of putting geear teeth on the outside edge of turret, then adding a small gear to the motor to increase the torque.
License
More from jgaither
Does the turret turn up side down from its pictured orientation to meet the base? Then the outer ring on the turret would retain the hose, yes?
What size hose are you planning to use?