Toothbrush and toothpaste holder in two parts.
by Tactyle, published
The hole for the tooth paste is 5 cm in diameter, the 4 holes for tooth brush is 2 cm, this should fit most brands.
I do not have a 3d printer yet, so i am unable to make it myself.
I am getting a 3d printer in october, until then i will be making stuff and uploading here, any feedback is welcome.
Recent Commentsview all
Create on a K8200. Needed to enlarge 8X and it came out nicely. The only issue I has (which is not the design) is that very near the end of the print of the top piece, the object came off the bed, so I lost the last 1/4in of height.
The open bottom is a little weird. Probably would close that off.
Thanks for the design.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.