Ultimaker Extruder Removal screw
21
Likes
256
Downloads
848
Views
Published on May 29, 2011
Description
It helps to clean the drive shaft after many many successful builds. Center is a M13 hole that encloses the nut.
Its a derivative of thingiverse.com/thing:8190
youtube.com/watch?v=TGXkQ0qusIg
youtube.com/watch?v=ShVZJ9ULa7g
Its a derivative of thingiverse.com/thing:8190
youtube.com/watch?v=TGXkQ0qusIg
youtube.com/watch?v=ShVZJ9ULa7g
Instructions
No instructions provided.
You must be logged in to post a comment.
Jaknil
on
January 22, 2012
said:
I knew somebody else would have made one of these already! I'll print it at my first opportunity and try to spread the word. I bet it works great. Thanks!
elmom
on
June 3, 2011
said:
That would actually be M8, the number references the diameter of the thread/screw. But should be useful :)
License
Ultimaker Extruder Removal screw by bkubicek is licensed under the Attribution - Non-Commercial - Share Alike license.
More from bkubicek
I made one and it looks great but what's the purpose? Can't you just remove the hobbed bolt by removing the clip on the other side and pulling the bolt out with the big wheel? It seems like once the bolt and nut are tightened in the optimum position, it's best not to loosen them. I must be missing something or maybe Ultimaker has changed something in the design and my recent model is different.