Bicycle seatpost light mount
8
Likes
535
Downloads
665
Views
Published on June 2, 2011
Description
Someone needed a mount for a Bell light, so I threw this together. The seatpost clamp design was borrowed from the typical reflector mount and could also be used for other stuff... like reflectors. The light mount can also be generated from the scad file with a tab to make it removable with those wedge tension clip things.
Instructions
For better curves, print the seatpost mount with close support. The hinge is a bit of wire clothes hanger, ideally grease it up and press it in.
More from dreameredeemer
You must be logged in to post a comment.