Coin cup holder
by shack90, published
Coin holder 1 is 1.1 inches tall and holds 1 inch of coins,
Coin holder 2 is 2.1 inches tall and holds 2 inch of coins,
Coin holder 3 is 3.1 inches tall and holds 3 inch of coins,
Coin holder v2 is 3 inches tall and holds 1.5 inch of coin.
The Version 1 of this is for shallow cup holders.
Coin Holder V3 is 2.1 inches tall and holds 2 inch of coin and has a hole all the way threw to allow a base to snap on to it. I have upload 5 different base sizes from 1 inch to 2.5 inch so you can print the top section that holds the coins and pick witch base that will give you the right height for you cup holder. Also this will make it handing if you decide to move it to a different cup holder that all you have to do is print a new base and not the hole thing. another plus is now you can rotate the coin holder.
I have all so upload a coin holder lid that will snap on the top so when you move your coin holder you won't lose any of you coins.
The base and lid will be snug so you make need to do a little clean up to make them if as easy as you want.
Recent Commentsview all
Thanks for the model! Going to put this in my car immediately - I would recommend making the cap as long as the holder; coins can still fall out with the cap on. Note that, in PLA, the center part of the lid does not fit in the recessed hole without sanding. Printed 'low', 10p infill, PLA, replicator 2, 2.5hrs, 81g of plastic. Super size options as well.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.